Instructions For Use - Lakeland Touchscreen Bean to Cup Instruction Booklet

INSTRUCTIONS FOR USE

1. When you switch on the appliance for the first time there may be a slight burning
smell. This is normal for a new product and will disappear after a few uses.
2. Check grinder basket before use for the presence of foreign objects.
3. Fill the coffee jug with fresh cold tap water.
4. Lift the water reservoir lid and fill the water reservoir with the water from your coffee jug.
5. Then close the water reservoir lid.
WARNING: To avoid the risk of burning or scalding from hot coffee or steam do not
use more than 500ml of water or fill beyond the '4 cup MAX' mark inside the tank or
the appliance may spit boiling water. Always use a minimum of 150ml of water.
6. Place the empty coffee jug onto the warming tray.
8. Switch on the appliance by touching the ON/OFF icon, the LED will stop flashing and
the appliance will enter into the standby mode.
PLEASE NOTE: If no icon is touched within 2 minutes under standby mode, the
appliance will automatically enter into the off mode.
9. Select the strength you require, strong coffee or light coffee mode.
7. Add 11g of fresh coffee beans or ground coffee. You
can add more or less according to your taste, but always
use a minimum of 7g and a maximum of 28g. Do not
fill beyond the 'MAX' mark inside the filter.
PLEASE NOTE: Ensure that the coffee beans or ground
coffee DO NOT fall into the water inlet, otherwise this
will cause the appliance to malfunction.
13