HoMedics spa REFLECTIVES M-8006 Instruction Manual And Warranty Information page 3

Illuminated Beauty Mirror Features
• Illumi-Touch™ Control – Select from 3 light settings with
a gentle touch of the mirror base
• Variable Light Setting – Choose from day, office or
evening illumination
• Incandescent Light – Soft glare-free & shadow-free viewing
• 7x/1x Magnification – Two-sided mirror with normal and 7x
magnification
• 8.5" Diameter
• Stable, non-slip base
• Fog free
• Mirror Measures 11"L x 7.5"W x 17"H
• Polished Chrome Finish with cherry wood finish accent
• Analog clock in base
• Includes one replacement light bulb
Instructions for Use
1. Carefully remove all contents from the packaging and inspect
the product to make sure all components have
been received (Fig.1).
2. Remove protective plastic coating from mirror face.
3. Place mirror on an even surface.
4. Adjust the mirror to either normal or magnified viewing. To do
so swivel the mirror to the viewing side of your preference
while firmly holding down the base.
5. Plug unit into a 120V household outlet.
6. Select the light setting of your preference with the Illumi-Touch
control feature. Touch the base of the mirror to activate:
•Touch once for evening (Low)
•Touch a second time for office (Medium)
•Touch a third time for day (High)
•Touch a fourth time to turn off
Note: The mirror casing may be hot after prolonged use.
Be cautious when adjusting the mirror face.
4
To Replace Bulb:
Caution: Before replacing the bulb, always turn mirror off and allow it to
cool for at least 5 minutes.
• Remove the three screws on the side of the mirror with a Phillips
screwdriver (Fig. 1).
• Take off the mirror casing by gently pulling apart at the seam.
• Unscrew light bulb and replace with a new one. For your conven-
ience, one replacement bulb is included. Light bulb is 120v, 25 Watt,
Type T.
• Replace the mirror casing and line up the screw holes.
• Screw back into place.
Setting the Clock
NOTE: Clock requires 1 SR626SW battery (included).
1. Remove clock from base by pulling it out (Fig. 1).
2. Remove rubber ring from the clock.
3. Pull dial out and twist to adjust the time (Fig. 2). When time is set
push dial back in.
4. Place the rubber ring back around the clock and push back into
mirror base.
Unscrew to
replace bulbs
Rubber Ring
Clock
Replacement Bulb
Figure 1
Mirror
Casing
5
Figure 2
Dial