Advertisement
INSTALLATION INSTRUCTIONS
Assemble the required tools and parts before starting the installation. Read and
PARTS SUPPLIED
Non-Swivel Models
E-46,NE-46, E-42,
NE-42, IAW-42
Swivel Models
AE-46, AE-42, ANE-46,
ANE-42, UD-42
follow the instructions provided using the tools listed.
TOOLS NEEDED
Stud Finder (Optional
Carpenter's Level
Tape Measure
Utility Knife
Drill (Electric Recommended)
1/4" drill bit (Surface Mount)
Look for the small plastic bag attached to the bottom bar of the
ironing board. This bag contains the supplied parts.
Recessed Installation / four - #10 x 1 1/2" wood screws
Surface Mounting / two - #14 x 4" wood screws
(IAW-42 only / two - #14 x 2 1/2" wood screws)
Recessed Installation / two - #10 x 1 1/2" wood screws for
top portion of cabinet
two - #14 x 2 1/2" Phillips screws for top side brackets
Surface Mounting / two - #14 x 4" wood screws
ROUGH-IN KIT
Rough-In Kit available for use prior to drywall being installed. Great
for new construction or open wall reconstruction when remodeling.
Rough-In Kit simplifies installation at a later date when room
completed and wall coverings and trim have been applied.
1/4" Nut Driver (Optional)
1/8" Drill Bit
Safety Glasses
Small Flat Head Screwdriver
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Iron-A-Way E-46
Summary of Contents for Iron-A-Way E-46
-
Page 1: Installation Instructions
Recessed Installation / four - #10 x 1 1/2" wood screws Non-Swivel Models Surface Mounting / two - #14 x 4" wood screws E-46,NE-46, E-42, (IAW-42 only / two - #14 x 2 1/2" wood screws) NE-42, IAW-42 Recessed Installation / two - #10 x 1 1/2" wood screws for... - Page 2 * The suggested distance from the side of the ironing board where the user typically stands to ensure adequate space for ironing. Cut an opening in the wall per the opening sizes shown below. Model Opening Size AE-46, ANE-46, E-46, & NE-46 14 3/8" x 59 7/8" x 3 7/8" UD-42 14 3/8" x 59 7/8" x 3 7/8"...
- Page 3 Height Chart below for the proper height of the various installation configurations. Make sure you use the correct model when selecting your board height. It is recommended a surface mount kit be installed when surface mounting recessed units. AE-46 E-46 AE-42 E-42 ANE-46...
- Page 4 ELECTRICAL INSTRUCTIONS WARNING: TURN OFF POWER AT SERVICE ENTRANCE BEFORE INSTALLING, WIRING OR SERVICING THIS PRODUCT. All electrical work must be done in accordance with all applicable electrical codes. NOTE: Opening in the top of the ironing center cabinet electrical supply wire is located 2 1/4" on center from left side for the of cabinet and 2 1/4"...
Need help?
Do you have a question about the E-46 and is the answer not in the manual?
Questions and answers