1. Manuals
  2. Brands
  3. Iron-A-Way Manuals
  4. Ironing Centers
  5. UD-42
  6. Owners & installation manual

Iron-A-Way UD-42 Owners & Installation Manual

Hide thumbs Also See for UD-42:
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

Installation
Manual
MODEL: UD-42

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UD-42 and is the answer not in the manual?

Questions and answers

Related Manuals for Iron-A-Way UD-42

Summary of Contents for Iron-A-Way UD-42

  • Page 1 Installation Manual MODEL: UD-42...
  • Page 2 GET TO KNOW YOUR UNIT (BOTTOM OF RACEWAY) 1. CROSS BRACES 4. ELECTRICAL OUTLET 2. ELECTRICAL RACEWAY 5. HOT IRON REST 3. SIDE BRACKETS Supplied Parts: Tools Needed: Recessed Mounting: - Stud Finder - 1/4” Nut Driver - Two #10 x 1 1/2” wood screws for top (optional) - 12-14”...

  • Page 3: Pre-Installation

    PRE-INSTALLATION Mounting 1. DETERMINE MOUNTING HEIGHT Desired Ironing Height Above Board Height Using the charts provided, determine Floor the mounting height above floor (the 16” 32” distance between the floor and the 15” 31” bottom of the cabinet). First choose your desired ironing board height 14”...
  • Page 4 3. ENSURE ADEQUATE SPACE Refer to provided chart to ensure adequate clearance for ironing. The cabinet door opens at 180 degrees; allow 16” from side of cabinet for door to fully open. 1. Distance needed on either side of unit to fully swivel the board ”...

  • Page 5: Recessed Installation

    RECESSED INSTALLATION Note: Instructions assume wall studs are spaced 16” on center. 3. PRE-DRILL HOLES 1. CUT WALL OPENING Your unit will be attached to the studs by Cut an opening into the wall based screws in the upper and lower sides of on dimensions given below.
  • Page 6 6. INSTALL UNIT IN WALL Ensure that power is Begin installation by carefully lifting unit disconnected at service into the wall opening. Make sure the entrance before proceeding. cabinet is plumb and level. If needed, add shims to help unit fit snug in place. 4.
  • Page 7 11. REPLACE RACEWAY COVER 8. REMOVE BRACKET SCREW Locate side ironing board brackets Place the raceway cover into that are secured to cabinet with position, ensuring that no wires three screws. Then remove the are pinched. Reinstall the top and top screw from each bracket.

  • Page 8: Surface Mount Installation

    SURFACE MOUNT INSTALLATION 1. PREPARE CABINET 4. PARTIALLY INSERT SCREW Screws will be drilled through the upper Partially insert a #14 x 4” screw and lower cross braces (see illustration in the upper cross brace. on pg.3) inside the cabinet. Determine location of screws, ensuring that the Ensure that power is location of the mounting screw is as...

  • Page 9: Connect Wires

    6. INSTALL ELECTRICAL WIRING 10. REMOVE BRACKET SCREW Verify that there is ample supply wire Locate side ironing board brackets available to run from the top of the that are secured to cabinet with ironing center to the approximate three screws. Then remove the top location of electrical pigtails.

Table of Contents