Polaroid MP-4 Assembly And Use page 2

This product
has
been approved
by
Under-
rrriters
Laboratories,
Inc.
(UL).
As
a condi-
tion of
approval
UL
requires
that
the
following safetl- information
be
provided.
IM
PORTANT SAFEGUARDS
AS WITH ANY
ELECTRICALLY OPERATED
EQUIPMENT,
BASIC SAFETY PRE.
CAUTIONS SHOULD BE
OBSERVED. REMEMBER:
I.
FOLLOW
ALL INSTRUCTIONS.
2.
DO
NOT
LEAVE
UNIT UNATTENDED.
3.
IF UNIT WILL
NOT
BE USED FOR
EXTENDED PERIOD
OF
TIME,
UNPLUG
FROM ELECTRICAL
OUTLET. GRASP
PLUG,
NOT CORD,
AND PULL TO
DIS-
CONNECT FROM OUTLET.
4.
DO NOT OPERATE
UNIT WITH
DAMAGED CORD,
OR UNIT WHICH
HAS
BEEN DROPPED
OR DAMAGED,
UNTIL IT
HAS BEEN EXAMINED BY AUTHOR-
IZED SERVICE CENTER.
5.
DO NOT LET
POWER
CORD HANG
OVER
FRONT
EDGE OF
TABLE
OR
COUNTER
OR
TOUCH
HOT SURFACES.
6.
UNiT
MUST BE GROUNDED.
POWER
CORD HAS THREE-PRONGED
GROUNDING PLUG,
WHICH MUST BE PLUGGED
INTO
APPROPRIATE OUTLET.
IF
SUCH
AN
OUTLET
IS
NOT
ALREADY
AVAILABLE,
EXISTING
OUTLET MUST
BE
CHANGED. DO
NOT, UNDER ANY CIRCUMSTANCES, REMOVE GROUND
PRONG
FROM PLUG*.
7.
IF
EXTENSION CORD
IS
NEEDED, USE
CORD
WITH
GROUNDING PLUG*
AND SUITABLE CURRENT RATING. CORDS RATED FOR
LOWER AMPERAGE
THAN UNIT MAY OVERHEAT. ARRANGE
CORD SO
THAT IT WILL NOT
BE
TRIPPED
OVER
OR PULLED.
8.
THE
LAMPS
GET HOT.
DO NOT TOUCH
THEM OR PLACE
THEM
EXCES-
SIVELY CLOSE TO
CAMERA BELLOWS,
DRAPES OR
CLOTHING.
9.
BEFORE STORING, ALLOW LAMPS
TO
COOL COMPLETELY. DISCONNECT
POWER CORD
AND
LOOP
IT
LOOSELY
AROUND CAMERA COLUMN.
10.
TO AVOID ELECTRICAL SHOCK
HAZARDS, DO NOT ATTEMPT TO
OPEN
SWITCH
UNIT
OR
OUTLET UNITS, AND DO NOT IMMERSE
THEM IN
WATER
OR
OTHER
FLUIDS. DO NOT OPERATE UNIT NEAR
WATER OR
WITH WET
HANDS.
IF
SERVICE
OR REPAIR WORK
IS
REQUIRED, CONTACT
AUTHORIZED
SERVICE
CENTER.
-THIS
APPLIES ONLY
IN COUNTRIES WITH GROUNDED ELECTRICAL SUPPLIES.
PLEASE KEEP
TH
ESE INSTRUCTIONS