Dry - Daewoo MINI DWC-M25CW User Manual

Dry

Use this course to dry everyday items like towels, socks, and dress shirts and regular laundry.
1
1) Turn on the washer by pressing the Power
button (①).
2) Open the drum door.
Press the Door Release button (②) to open the drum door.
3) With the door open, place the laundry
inside the drum and then close the door
shut.
• Make sure to close the detergent and fabric-softener
drawers completely before proceeding.
※ Do not use detergent or fabric softener with Dry course.
※ Limit the load size to 1kg when using the Dry course.
※ Exceeding the recommended laundry-load size may
result in abnormal noise, abnormal vibration, and/or a
malfunction.
The course lasts for 59 minutes at 87 °C.
Note:
- Do not use detergent or fabric softener.
- Pressing the Power button and then the Start/Pause button starts the wash cycle using the initial auto-selection settings.
- Refer to the drying capacity and limit the load size to less than 1kg.
- Keep the water valve open (a small amount of water is drawn and drained for improved drying performance).
- is displayed on the LED display once the dry cycle is completed, and the door is unlocked once the temperature drops to a
certain level.
- The dried items may be hot. Be careful when taking them out of the washer.
- Some shrinking and/or deformation may occur depending on the fabric of the clothing (make sure the item is safe to dry using heat beforehand).
- The items are deliberately left slightly damp to prevent damage and wrinkling. If you are not satisfied with the residual dampness, dry the items
more.
- If there is too much water inside the drum, the washer will drain some of it for safety.
- Pressing the Start/Pause button during the dry cycle will show the FA message on the LED display and then the door will be released once the
temperature inside the drum drops to a safe level.
- Q: During the dry cycle, pressing the Start/Pause button doesn't stop the washer.
A: If the washer is paused or turned off during the dry cycle, the washer will continue to run its fan until its internal temperature drops to a safe
level in order to protect itself from damage. Once this cooling phase has ended, the drum door will open so that you can take out the laundry.
- Au, Test Load 1.0kg, 230V use programme in accordance or in conformity with AS/NZS 2442.1
2
4) Use the Dry button (③) to configure the
5) Press the Start/Pause button (④).
Tip
"If you wish to wash and dry your laundry in a single step, use the Wash
| 27 |
3
settings.
• Use the Dry button to configure the settings.
※ Each press of the Dry button cycles through the settings
as follows:
AUTO → 30 (30 mins) → 59 (59 mins) → 90 (90 mins) →
2H (2 hrs) → 3H (3 hrs)
※ AUTO chooses the most suitable drying time based on
the weight of the load and displays the remaining time on
the LED display.
※ AUTO chooses from 59 mins, 120 mins, and 180 mins
based on the weight of the laundry load and starts drying
the laundry automatically.
※ AU is shown on the LED display.
The door will lock and the dry cycle will begin.
& Dry course."
4