Installation - Cecilware HWD2 Operator's Manual

Rough-In Drawing (continued)
HWD5
CECILWARE
29.8
9.3
Installation (continued)
WARNING: ELECTRIC SHOCK HAZARD!
Installation of this appliance should be performed by
qualified service personnel only. Improper installation
could result in electrocution.
Unpacking Instructions
Carefully unpack the machine and inspect immediately
for shipping damage. The packaging may contain
unattached parts. Your machine was shipped in a carton
designed to give it maximum protection in normal
handling. It was thoroughly inspected before leaving
the factory. In case of damage, contact the shipper, not
Grindmaster-Cecilware.
See Rough-in Drawing for approximate dimensions
and locations of electric and water input.
NOTICE:
This equipment must be installed in
compliance with applicable Federal, State, and/or Local
plumbing codes having jurisdiction. This product requires
an approved back flow prevention water device, such as
a double check valve, to be installed between the
appliance and the water supply. Incoming pressure
should be greater than 20 psi and not more than 90 psi.
4
Hot Water Dispenser
15.3
1.3
7.0
•
Connecting the unit to a warm water supply will
speed up heating and recovery times.
• A filtering system is recommended to remove odors
and inhibit lime and scale build up in the unit.
• In areas with extremely hard water, a water softener
must be installed in order to prevent a malfunctioning
of the equipment and in order not to void the warranty.
NOTICE:
Do not use extension cords. Make sure that the
outlet the unit plugs into is grounded. Check rating
marking on nameplate to be sure electric lines match
voltage, phase, and amperage requirements of
appliance.
NOTICE:
Do not turn activate heater until all
installation instructions have been followed.
1. Connect a ¼" diameter copper waterline to the ¼"
flare water inlet.
2. Open the water shut-off valve and check
connections for leaks. DO NOT over-tighten.
3. Plug in the Hot Water Dispenser into a dedicated
power supply outlet.
4. Activate the Power Switch (front of unit) the water
tank will begin to fill, providing the water
Cecilware
®
12.0
Hot Water Dispensers
29.0
0.7