Information And Troubleshooting - Bobrick CompacDryer B-710 Troubleshooting And Information Manual

Information and Troubleshooting for the B-710 CompacDryer
TM
For complete set of Installation Instructions refer to form No. 710-69
Information about the Dryer:
• Model B-710 CompacDryer is not designed for vandal-prone installations. For vandal-prone
TM
installations use Bobrick AirCraft dryers with cast-iron, vitreous enamel finished covers.
®
• Only the cover and the electronic controller are available for replacement.
Product Types:
B-710 Series A B-710 Series B
Electrical Characteristics:
115V, 15A, 1725W, 60 HZ, cULus listed.
220-240V, 7A, 1500-1700W, 50/60Hz, VDE approved, CE marked.
Removal of Cover:
Remove three screws, one from each side
and one from the bottom of the dryer. Pull
bottom of the cover away from the mounting base.
Warning Disconnect power
If a fault occurs with the dryer:
Risk of electric supply before
shock removing cover
1. Check that the electrical supply is OK.
2. Check that the circuit breaker is switched on.
3. Check that sensor is clean and not obstructed.
Replacement Parts:
710-250 Series B cover 115V
710E-150 Series A cover 220-240V
710-360 Controller 115V
710-361 Controller 220-240V