Table of Contents
Advertisement
2 - Operation
■
What type of alarm occurred?
When an alarm signal is displayed, you can fi nd out what type it is (intru-
sion, technical, etc.) and which detector has detected it; a name has been
given to each detector (kitchen window, entrance, etc.) by the installer for
easier identifi cation. Press just one key to get this information.
The Unit has detected an alarm...
To learn more, press the
key
The display provides the following infor-
mation:
- detector and its name (living room win-
dow)
- type of alarm (intrusion)
- burglar-alarm (antitheft) status when
the alarm goes on (ON-inserted)
The alarm notifi cation is cancelled from
the display when the burglar alarm
system is rearmed. It is however saved
in the "Event Memory" of the Burglar
Alarm Control Unit
In case of a technical alarm (its symbol appears), you can fi nd out which
device has produced the alarm and reset it as well.
The Unit has detected a technical alarm
1 2 3 4
To learn more, press the
32: IR sensor
Living room window
The display provides the following
Intrusion Alarm
information:
Inserted
- device name (remote assistance)
- type of alarm (technical start)
- burglar-alarm (antitheft) status when
1
2
3
4
5
6
7
8
9
0
By pressing the
ars, which lets you reset a single alarm
or execute a total reset
18
the alarm goes on (OFF-disconnected)
key, a page appe-
1 2 3 4
42: riceiver
Remote Assistance
Start Technical
Disconnected
Press:
reset single
reset total
Advertisement
Table of Contents
