WMF CASHMIRA Operating Manual page 10

Start-up
Prior to first use and after the unit has not been used for longer periods, perform
a boiling process with fresh water without coffee grounds. Fill the tank with fresh
water only to the mark for 7 cups.
Then rinse the filter and pitcher with hot water.
Set current time
After plugging the plug into an outlet, the display shows "12:00".
Press the Prog key. The display shows "CLOCK" and the colon of "12:00" is blinking.
You can now set the current time by pressing the h and min keys. When "CLOCK"
disappears from the display, the clock is running. Confirmation is not required.
Note: The time must be reset after a power failure or after the plug was disconnec-
ted.
Programming the activation time
The automatic activation of the unit independently starts the brewing process at the
desired time. The activation time can be programmed up to 24 hours in advance.
Press the Prog key twice. The display shows "TIMER" and the colon of "00:00" is
blinking. You can now change the activation time by pressing the h and min keys.
When "TIMER" disappears from the display, the new activation time is programmed.
You can check the activation time at any time by pressing the Prog key twice.
Note: The activation time must be reprogrammed after a power failure or after the
plug was disconnected.
Making coffee
Fill only cold water into the water tank. The water level display applies to the
amount of fresh water which is needed to brew the desired number of cups, each
containing 125 ml.
Open the lid to add coffee grounds. Put a 1 x 4 paper filter into the filter, first
slightly folding the embossed edge over. The paper filter must not protrude beyond
the edge of the filter and should therefore be slightly pressed down by hand.
Add the required amount of coffee grounds. Depending on personal taste, use
approx. 5-7 g of moderately finely ground coffee per cup. The filter may overflow if
it is too finely ground.
Automatic activation
To start brewing automatically at the programmed activation time, press the Prog
key three times. The right indicator light lights up blue.
Brewing starts automatically at the programmed activation time. The right indicator
light goes out; the left indicator light lights up blue.
Immediate start
To start brewing coffee immediately, press the Start/Stop key
. The left indicator
light lights up blue, and brewing starts.
You can stop brewing at any time by pressing the blue lit Start/Stop key
again.
Wait until the coffee has completely run into the pitcher. After the pitcher is
removed, a drip stop valve prevents remaining coffee from dripping onto the heating
plate.
Automatic shut-off
After the brewing process, an automatic shut-off function stops the unit from
overheating. The unit only shuts off when the water has completely run through.
10