Table of Contents
Advertisement
Installation and Operations Manual — Model 400 Series
Close Button
Locking Pin Open Limit Switch
Safety Stop Jumper
Gate Close Limit Switch
Gate Open Limit Switch
Safety Devices
Stop Button
Locking Pin Close Limit Switch
Emergency Close Button
Loop Detector – One loop detector and harness come pre-wired for use as a
safety. Two loops can be wired in series and connected to inputs #7 and #8 on the
loop detector harness. If you wish to use a loop as a free exit, contact B&B
ARMR for prices or wiring information.
B&B ARMR
A Division of B&B Roadway and Security Solutions
TROUBLESHOOTING
Button to close gate – Normally Open
Button common to I1
Button point to 24-volt dc+
Jumper required for non 450 gates
Switch common to I2
Switch point to 24-volt dc+
Jumper installed makes gate stop instead of
open when a safety device is detected.
Jump 24-volt dc+ to I3
Switch must be wired for the gate to work
Switch common to I4
Switch point to 24-volt dc+
Switch must be wired for the gate to work
Switch common to I5
Switch point to 24-volt dc+
Switch common to I6
Switch point to 24-volt dc+
Button to stop gate – Normally Closed
Button common to I7
Button point to 24-volt dc+
Jumper required for non 450 gates
Switch common to I10
Switch point to 24-volt dc+
Closes gate regardless of Safety Devices
Button common to I11
Button point to 24-volt dc+
20
04X0 Rev G
Advertisement
Table of Contents
