Table of Contents
Advertisement
To change the "Second Time to Calibrate" setting, after entering the programming mode, press and
hold the "ON" button. Then press and hold the "Heavy Pad Pressure" button. Release the "ON"
button, then release the "Heavy Pad Pressure" button. A combination of lights will illuminate in the
pad pressure array. By pressing "UP" or "DOWN", the lights will move accordingly. The closer the
array is to the word "MIN", the quicker the machine will recalibrate itself after the initial calibration
level has been found. The closer the array is to the word "MAX", the longer it will take for the machine
to recalibrate itself. This functions just like the "first time to calibrate" described above. Once correct
adjustment has been made, press "Off" button to exit the programming mode and save the setting.
To reset the machine back to its factory sensitivity settings, after entering the programming mode,
press and hold the "Heavy Pad Pressure", "Medium Pad Pressure", and "Light Pad Pressure" buttons.
Then release the "ON" button and then simultaneously release the other three buttons. Most of the
lights on the control panel will blink at random. To reset to the factory settings, press the "UP" button
and then press the "OFF" button to exit the programming mode.
Power to the control board must be disconnected to disable the programming mode. This can be
most easily done by pressing the red emergency stop button. All values will be stored in the memory.
CAUTION: Machine will not be used on surfaces with a gradient exceeding 2%.
The machine shall be used only instructed and authorized persons. When cleaning, servicing or
maintaining the machine, replacing parts or converting to another function the power source shall be
switched off. Operated machines shall be disconnected by removing the power plug and battery-
operated machines shall be disconnected by removing the key of the power switch or any other
effective means.
Before use, all covers and doors shall be put in the position specified in the instructions for use.
For machines with traction drive and a mass exceeding 100 kg:
·
In order to prevent unauthorized use of the machine the power source shall be switched off or
locked, for example, by removing the key of the power switch.
·
Machines left unattended shall be secured against unintentional movement.
·
During operation attention shall be paid to other persons, especially children.
7
Advertisement
Table of Contents
