Count Direction - Pilz PSEN enc m2 eCAM Operating Manual

Installation / Preparation for commissioning

5.7 Count direction

Fig. 11: Setting the count direction
M1: Setting for measuring channel 1
M2: Setting for measuring channel 1
Permitted switch settings measuring channel 1/ measuring channel 2:
DIP 1
OFF
ON
34
DIP-Schalter 2 Count direction
Increasing in clockwise direction, viewed towards the flange
ON
connection
Decreasing in clockwise direction, viewed towards the flange
OFF
connection
M2
NOTICE
The count direction for measuring channel 1 and
measuring channel 2 must be set in opposite
direction!
M1