Daikin DCG Series Service Instructions Manual page 5

PRODUCT IDENTIFICATION
Factory-Installed Options
• Stainless-Steel Heat Exchanger (Gas units only): A tubular heat exchanger made of 409-type stainless steel is installed in the unit.
•
to 0°F outside air temperature.
•
•
• Non-powered Convenience Outlet: A 120V, 15A, GFCI outlet makes it easier for technicians to service the unit once an electrician runs
power to the outlet.
• Powered Convenience Outlet: A 120V, 15A, GFCI outlet powered with a transformer built into the unit. When a factory-installed powered
convenience outlet is installed in the equipment, the unit MCA (Min. Circuit Ampacity) will increase by 7.5A for 208/230V units, increase
• Disconnect Switch (non-fused; 3-phase units only): A disconnect switch is installed in the unit and factory wiring will be complete from
the switch to the unit.
kit must be ordered to be factory-installed along with the disconnect switch (non-fused) when it is ordered. Please note that for models
• Return Air and/or Supply Air Smoke Detectors: Return air and/or supply air smoke detectors are installed in the unit.
• Hinged Access Panels: Allows access to unit's major components. Combined with latches for easy access to control box, compressor,
• Two-speed indoor fan blower models are available on 6, 7½, 8½, 10, 12½, 15, 20 & 25 ton units.
Energy Commission Title 24 2013 contains a similar provision. When the units with the two-speed indoor fan blowers operate on a call
stage of cooling, the fan operates at full speed.
operates at low speed.
When the units operate on a call for the second
5