Table of Contents
Advertisement
SPECIFICATIONS
Amplifier Section
#
Power output ...................................................................................................................600 W (20 Hz to 20 kHz, T.H.D., 0.2 %, 4 Ω)
Rated distortion ........................................................................................................Less than 0.03 % (20 Hz to 20 kHz, 300 W, 4 Ω)
Signal-to-Noise Ratio (IHF, short circuited, A network) .......................................................................................... 125 dB or higher
Frequency response ........................................................................................................................................ 1 Hz to 100 kHz,
Gain ..............................................................................................................................................................................................29.5 dB
Input terminal (Sensitivity/ Impedance) ........................................................................................................................ 1.5 V / 220 kΩ
Power section/miscellaneous
#
Power requirements .......................................................................................................................................... AC 230 V, 50 Hz/60 Hz
Power consumption ..................................................................................................................................................................... 520 W
Dimensions ...................................................................................................................... 516 mm (W) × 297 mm (H) × 622 mm (D)
Dimensions (When using spike bases) ......................................................................... 516 mm (W) × 307 mm (H) × 622 mm (D)
Weight ..........................................................................................................................................................................................90.0 kg
Accessories
#
Power cord .............................................................................................................................................................................................1
Spike bases ............................................................................................................................................................................................4
Spike base template ..............................................................................................................................................................................1
Hexagon wrench ....................................................................................................................................................................................1
Operating Instructions (this document) ..............................................................................................................................................1
Note
Specifications and the design are subject to possible modifications without notice, due to improvements.
'
To ensure long product life, avoid installing this unit in the following locations:
•
Locations exposed to direct sunlight.
•
Humid or poorly ventilated areas.
•
Areas of extreme temperatures.
•
Areas with vibration.
•
Dusty or smoky areas.
•
Areas exposed to grease fumes, steam or heat (such as a kitchen).
Maintenance
Use a dry polishing cloth to wipe off dust and dirt. If the surface is extremely dirty, wipe with a soft cloth dipped in neutral
cleanser diluted five to six times with water and wrung out well. Do not use volatile chemicals such as paint thinner or
benzenes, as these may corrode the surface of the panels. Do not use sprays such as insecticides around the TAD-M600. If
you plan on using a chemical cleaning cloth, read the precautionary statements of the chemical cleaning cloth before using.
300 W (20 Hz to 20 kHz, T.H.D., 0.2 %, 8 Ω)
TAD-M600
+0
dB
–1
15
Advertisement
Table of Contents
