Philips AVENT SCF870 User Manual page 9

Hide thumbs Also See for SCF870:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Hot steam or hot water could burn your fingers. Do not touch and never let children touch hot
parts and steam. They may cause scalds (Fig. 10).
When the steaming process is finished, the appliance produces a buzzing sound and the
,
steaming light goes off.
8
Set the control knob to the off position. Wait 2 minutes until no steam comes out of the
steam inlet. (Fig. 11)
If you want to serve the steamed baby food without blending it, test the food on the back of
your hand to make sure it is at a safe temperature for your baby.
9
If you want to continue steaming, turn the control knob to the steaming position again.
10
If you want to proceed with blending the steamed food, follow the steps below.
-
Grab the jar handle and lift the jar off the motor unit. Turn the jar around and shake it so that
the food falls down onto the blade unit (Fig. 12).
Only touch the jar handle. The lid, bottom and outer surface of the jar are hot (Fig. 13).
-
If necessary, remove the lid and add additional ingredients for blending (e.g. water or oil).
Always make sure that the lid has cooled down after steaming before you open it to add more
ingredients or to remove remaining water from the water tank.
-
Continue with steps 7-9 of section 'Blending'.
Blending
The appliance is intended for:
-
pureeing steamed and cooked ingredients for baby food
-
blending fluids and fruits for baby drinks
Note: When you blend fluids, make sure you do not fill the jar beyond the MAX indication on the jar.
The appliance is not intended for chopping hard ingredients such as ice cubes and sugar cubes.
1
Put the blade unit on the tool holder in the jar (Fig. 4).
2
Cut solid ingredients into small pieces (cubes not bigger than 1cm) before you put them in
the jar.
Tip: Do not process a large quantity of solid ingredients at the same time. Process these ingredients in a
series of small batches instead.
3
Put the ingredients in the jar. (Fig. 5)
4
Place the jar upright on the motor unit, i.e. with the lid opening upwards. Make sure the
handle is on the right-hand side and positioned between the two ridges of the locking
area (Fig. 14).
5
Put the sieve in the lid of the jar ('click') (Fig. 6).
6
Place the lid on the jar and slide it in position. The small projections on the lid have to fit in
the grooves in the jar. Make sure that the extension of the lid is placed exactly over the
handle of the jar. (Fig. 7)
7
Turn the control knob to the blending position. Hold the knob in this position for as long as
you need but for not more than 30 seconds (Fig. 15).
Note: If the ingredients stick to the wall of the jar, switch off the appliance and loosen them with the
spatula or add some liquid.
Note: Make sure that the blended baby food has the right consistency (e.g. no lumps) before you serve it.
EngliSh
9

Advertisement

Table of Contents
loading

Table of Contents