Advertisement
Wall/Ceiling Mounting Instructions:
CAUTION: Due to the weight of Sx100/300 series speaker
systems, it is imperative that the MBS200 bracket be prop-
erly secured to the wall or ceiling. The choice of fastener (not
provided with this kit) will be determined by the material and
construction of the mounting surface.
1. Refer to Figure 1 for the following steps.
2. Remove the paper backing from one of the friction pads
(F) and, making sure the holes are aligned, attach to the
U-bracket (A) as shown. Attach the second friction pad in
a similar manner.
3. Attach the U-bracket to the wall or ceiling using fasteners
(not supplied) that are suitable for the construction mate-
rial.
4. Remove the hole plugs from the ends of the Sx100/300
series speaker system by gently prying with a small screw-
driver.
5. Place one of the smaller lock washers (C) on each of the
two M8 bolts (B).
6. Place the speaker into the U-bracket and finger tighten the
M8 bolts.
7. Rotate the speaker so that the input panel is accessible
and attach the wires to the input panel.
8. Position the speaker for the desired coverage and gently
tighten the M8 bolts until the speaker will no longer rotate.
DO NOT OVERTIGHTEN.
NOTE: The 3/8-24 bolts (D) are used to lock the speaker
parallel to the bracket and prevent it from being rotated. This
is needed when arraying the speaker for proper alignment and
when flying in the vertical position.
Fig. 1 - Attaching the MBS200 Bracket to Sx100/300 Series
Speaker Systems
Flying Instructions:
NOTE: A maximum of two speakers can be suspended to-
gether vertically using the MBS200 installation bracket.
1. Refer to Figure 1 for the following steps.
2. Remove the paper backing from one of the friction pads
(F) and, making sure the holes are aligned, attach to the
U-bracket (A) as shown. Attach the second friction pad in
a similar manner.
3. Remove the hole plugs from the ends of the Sx100/300
series speaker system by gently prying with a small screw-
driver.
4. Place one of the smaller lock washer (C) on the M8 bolt
(B).
5. Place the speaker into the U-bracket and finger-tighten the
bolts.
6. For vertical flying (see Figure 5) or for horizontal position-
ing with the speaker perpendicular to the floor (straight
down), place the larger lock washer (E) on the 3/8-24 bolt
(D).
7. Position the speaker parallel to the bracket. The 3/8-24
hole should align with the groove in the speaker. Tighten
the bolt until the lock washer is compressed.
8. Gently tighten the M8 bolts until the speaker will no longer
rotate. DO NOT OVERTIGHTEN.
Item
Part Number
Qty Description
A
PAR000362
B
FST000071-000
C
HDW000012-000
D
FST000070-000
E
584014-000
F
38829
1.
OmniMount is a registered trademark of OmniMount Systems, Inc.
1
U-Bracket
2
M8 x 1.25" Hex Head Bolt
2
5/16" Split Ring Lock Washer
2
3/8"-24 Hex Head Bolt
2
3/8" Split Ring Lock Washer
2
Friction Washer
Advertisement
