Digital Guard Dawg 2GO KEYLESS iKEY RS Installation & User Manual page 5

Overview:
Completely read this manual and review the wiring diagram carefully.
It is recommended that you complete your installation in two parts.
Part 1~Installation of the Door Lock and Alarm module & Harnesses.
Part 2~Installation of the Push Button–Remote Start & Harnesses.
1. Always install in a well-lit, dry, covered area away from the elements and keep
at least one window open during installation to avoid a lock out.
2. Locate necessary wires related to the installation (most required wires are
under driver dash or kick panel areas). Use only a digital multi-meter to verify
signal wires. Please be aware of surrounding metal and prevent accidental
grounding of wires through various tools being used during the installation
process.
3. Disconnect the ground wire (-) terminal from the vehicle's battery prior to
making ANY connections. To avoid accidents, it is recommended to remove
related fuses from sockets before making connections and put them back
during the very last steps.
4. Mount the Control Module in a secure area, away from vehicle computers and
heating/air conditioning ducts. The location should be convenient for your
installation, but well hidden from thieves. Try to mount the unit as far away from
metal objects to increase the range of the iKey™ Transmitter.
5