ECOVACS DEEBOT 605 Instruction Manual page 25

No. Malfunction
DEEBOT is not able to connect
8
to the home Wi-Fi network.
Remote Control failure
9 (Effective control range of the
Remote Control is 5m (16')).
Possible Causes
Incorrect home Wi-Fi username or password
entered.
DEEBOT is not within range of your home
Wi-Fi signal.
Network setup started before DEEBOT was
ready.
Your smartphone's operating system needs to
be updated.
The battery in the Remote Control needs to
be replaced.
DEEBOT is powered OFF or DEEBOT's
battery is low.
The infrared signal cannot be transmitted
because the Infrared Emitter on Remote
Control or the Infrared Receiver on DEEBOT
is dirty.
There is other equipment interfering with the
infrared signal to DEEBOT.
6. Troubleshooting
Solutions
Enter the correct home Wi-Fi username and password.
Make sure DEEBOT is within range of your home Wi-Fi
signal.
Turn ON Power Switch. Press the RESET Button for 3
seconds. DEEBOT is ready for network setup when it
plays a musical tune and its Wi-Fi Indicator light flashes
slowly.
Update your smartphone's operating system. The
ECOVACS App runs on iOS 9.0 and above, Android 4.0
and above.
Replace with a new battery making sure it is installed
correctly.
Make sure DEEBOT is powered ON and fully charged.
Use clean dry cloth to wipe the Infrared Emitter on
Remote Control and the Infrared Receiver on DEEBOT.
Avoid using the Remote Control near other equipment
using infrared signals.
25
EN