Table of Contents
Advertisement
6.4 INSTALLING THE CHROTHERMOSTAT
ON THE WALL
First step, remove the cover containing the electronic
board by pushing the appropriate button trapezoid, that
says "PUSH", located on the lower unit and rotating
the cover itself up, until it is fully removed, as shown in
figure 3.
For the fixing on the wall is possible to use many holes
provided on the bottom of the base, in this case, see
Figure 4.
Then is possible to wire the circuit board unit using the
appropriate terminal, regardless of the polarity (the two
conductors can be exchanged).
It is recommended to use a twisted pair cable (example
H03RR-F o H03VV-F) size between 0,5 mm2 and 2,5
mm 2, the length should not exceed 50m. The resistance
of each conductor, in any case, should not exceed 5.
In environments with electromagnetic interference it is
recommended to use a shielded twisted pair cable.
6.5 DIMENSIONS FIXINGS
90,0
Base fixing holes, rear view (dimensions in mm)
9,00
9,50
5,00
18,25
External dimensions (dimensions in mm)
140,0
Instructions for unhooking the front panel
1) Press PUSH button
2) Rotate upwards
10,40
9,50
2,20
5,00
17,15
1,2
23
ø 3,80
30,8
Fig. 5
Fig. 6
Advertisement
Table of Contents
