Table Of Contents - a2b ACCORRONI MEC MIX C Series Technical Information

Modulating condensation, fixed power, axial and centrifugal condensation hanging hot air generators with pre-mixed modulating gas burner
Table of Contents

Advertisement

HOT AIR GENERATORS PRE-MIXED WALL UNITS
MEC MIX C CONDENSING SERIES
AXIALS AND CENTRIFUGES
MODELS 20/35 - 20/45 - 20/70 - 20/90
SERIES MEC MIX F AXIAL AND CENTRIFUGAL
This manual is separated into five sections:
- SECTION A - GENERAL INFORMATION
It contains all the news related to the description of the generators and their technical characteristics
- SECTION B - TECHNICAL NEWS FOR THE INSTALLER
It collects all the indications and the instructions that the installation technician must observe for the realization
of an optimal system
- SECTION C - HYDRAULIC INSTALLER
- SECTION D - ELECTRIC INSTALLER
- SECTION E - ASSISTANCE AND MAINTENANCE
Important notes for consultation:
1 - For the purpose of the correct and safe use of the appliance, the designer, the installer, the user and the
maintenance technician, for their respective competences, must scrupulously observe what is indicated
in this manual. It must be kept for possible consultation and must accompany the appliance throughout its
life, including the case of transfer to third parties.
2 -
With the wording ATTENTION! they follow information that, due to their importance, must be scrupulously
observed and whose non-compliance can cause damage to the appliance and / or jeopardize its safe use.
The paragraphs highlighted in bold contain information, warnings or important advice that is recommended
to evaluate carefully.
3 -
The A2B Accorroni E.G. Srl declines any responsibility for any damage caused by improper use
of the appliance, from a different use to the intended use and from an incomplete or approximate
application of the instructions contained in this manual.
4 -
The technical data, the aesthetic characteristics, the components and the accessories shown in this
manual are not binding.
The A2B Accorroni E.G. Srl reserves the right to make changes at any time deemed necessary for the
improvement of its product.
5 -
References to laws, regulations or technical rules cited in this manual are intended for information
purposes only and referred to the date of printing of the same, shown on the last page. The entry into force
of new provisions or changes to those in force will not constitute a reason for any obligation of A2B
Accorroni E.G. S.r. towards third parties.
6 -
The A2B Accorroni E.G. Srl is responsible for the conformity of its product with the laws, directives and
construction standards in force at the time of marketing. The knowledge and observance of the laws
and regulations concerning the design of the systems, installation, operation and maintenance are the sole
responsibility, for the respective skills, of the designer, installer and user.
1.
GENERAL WARNINGS ........................................................................................................................... 4
2.
SAFETY WARNINGS .............................................................................................................................. 4
2.1
Qualification of the installer ...................................................................................................................... 4
2.2
Power supply ........................................................................................................................................... 4
2.3
Fuel .......................................................................................................................................................... 4
2.4
Gas leaks ................................................................................................................................................. 4
2.5
Use ........................................................................................................................................................... 4
2.6
Transportation and handling .................................................................................................................... 4
3.
MAIN CHARACTERISTICS ..................................................................................................................... 5
3.1
Functional description .............................................................................................................................. 5
3.2
Constructive features ............................................... ............................................................................... 5
3.3
Table of MEC MIX C axial condensation technical data .......................................................................... 6
3.4
Technical data table MEC MIX F axial ..................................................................................................... 6
3.5
Centrifugal condensing MEC MIX C technical data table ...................................................................... 7
3.6
Table of MEC MIX F centrifugal technical data .......................................... ............................................ 7
3.7
MODELS 35 - 50 - 70 - 100
Technical information
INDEX
2

Advertisement

Table of Contents
loading

Table of Contents