Table of Contents
Advertisement
TURN ON X15 POWER
Though power is plugged in and the terminal is connected
there will be no activity observed on the terminal. LED D41
will glow.
To turn ON the X15 main power press the blue momentary
switch S1. This will cause LED D3 to glow showing that the
board power is ON.
BOOTING
At this point the software present in eMMC
will start to boot and activity can be seen on
the terminal.
USER LEDS
During the botting process the user may notice that the user
LEDs will blink.
D41 - 12V Present LED
D3 - POWER ON LED
X15 QUICK START GUIDE
S1
D41
D3
Figure 21 – POWER LEDs
Figure 22 – POWER LEDs
D4 D5 D6 D7
Figure 23 – POWER LEDs
16
Advertisement
Table of Contents
