BOOT STRAPPING
J3, J4 and J6 can be strapped with Shunts for different booting options.
See Figure 15 for details.
SERIAL DEBUG
Plug in the USB to Serial cable into the 6 pin header P10.
Observe correct orientation. Pin1 is located at the top side of
the header.
PIN NUMBER
SIGNAL
1
Ground
4
Receive
Transmit
5
TERMINAL SETUP
Plug the USB end into your PC or Laptop
and invoke MINICOM or TERATERM or your
favorite Terminal emulator program. The
settings for serial communications are:
X15 QUICK START GUIDE
Figure 15 – BOOT JUMPERS
Pin1
Pin6
Figure 16 – SERIAL DEBUG PORT
Figure 17 – TERMINAL WINDOW
14