Strength" Function; Coffee Brewing - Redmond SkyCoffee RCM-M1509S-A User Manual

Table of Contents

Advertisement

2. To set the hour value press HOUR, minute value – press MIN.
Press and hold the corresponding button to scroll through
the digits. The hour value changes irrespective of the minute
value. After the maximum value is reached the adjustment
starts again.
After 1 minute of idle time, the appliance will switch into the
standby mode.
3. After the end of adjustment press "Start/Cancel". The Time
Delay function will start its operation.
During the operation of the function the current time value is
displayed. To see the set Time Delay value, press "Hour" or "Min".
4. After the end of the function operation the appliance will
make three audible signals,
drink-making process will start.
5. To disable the Time Delay function repress "Start/Cancel". A
long audible signal will be heard,
the appliance will switch to the standby mode.

"Strength" function

This function allows to increase the intensity of the ready drink.
The hot water is supplied into the filter with coffee by 10 second
periods with 10-second breaks during the function operation.
Thanks to that the flavour and aroma of the ready drink become
more intense.
To enable the function in any mode of the appliance operation
press "Strength" button.
indicator will light up on the panel.
To disable the function repress the "Strength" button,
will go out.

Coffee brewing

1. Open the lid of the water tank and remove it by pulling up-
2. Open the filter holder by pulling it by the lock to the left.
indicator will go out. The
indicator will go out,
3. Set the carafe onto the metal plate for heating. Plug in the
4. To brew coffee in the automatic mode press the
5. After water tank is empty, the appliance will finish operation
6. After the end of operation the appliance will make three
indicator
SkyCoffee RСМ-М1509S-А
It is not recommended to use the strength adjustment button
when making more than 10 cups of coffee as it may lead to the
appliance overheating.
wards by the handle. Fill the tank with clear water. Fill the
tank with clean cold water not exceeding the maximum mark
and install it to the housing until tight. Close the lid.
Install the removable filter into the filter holder. Add the
ground coffee into the filter so that no less than a half of the
container was empty. Set the filter holder into the working
position, by turning it to the right until it clicks.
It is not recommended to tamp ground coffee in the filter. Use
medium ground coffee, suitable for the drip coffee makers. When
making coffee from beans of different grinding, the filter filling
degree may be slightly different.
appliance.
will light up.
in coffee making mode and switch to the mode of keeping
the ready drink warm.
audible signals and switch into the standby mode, the indica-
ENG
indicator
11

Advertisement

Table of Contents
loading

Table of Contents