Synology DiskStation DS2419+ Hardware Installation Manual page 11

3 Insert the new RAM module in the slot:
a Align the notch on the gold edge of the module with the notch in the memory slot. Then tilt the card and
insert the module into the slot. Make sure the module is properly inserted.
b Push the RAM module with moderate pressure into the memory slot until you hear a click.
Note:
• Hold the memory module by its edges, and do not touch the gold connectors.
• When memory capacity is changed, the device will perform a memory check upon the next start up. This will
prolong the start up time by up to ten minutes. This behavior is normal and will only occur once.
4 Replace the side panel. Replace and tighten the 2 screws you removed in step 2-a.
11 Chapter 2: Hardware Setup