Safety Instructions And Measures - Samson 44-7 Mounting And Operating Instructions

Safety instructions and measures

1 Safety instructions and measures
Intended use
The SAMSON Type 44-4, Type 44-7 and Type 44-8 Pressure Regulators are suitable for
pressure control of liquids and gases. The regulators are designed to operate under exactly
defined conditions (e.g. operating pressure, process medium, temperature). Therefore,
operators must ensure that the regulators are only used in operating conditions that meet the
specifications used for sizing the devices at the ordering stage. In case operators intend to
use the regulators in other applications or conditions than specified, contact SAMSON.
SAMSON does not assume any liability for damage resulting from the failure to use the de-
vice for its intended purpose or for damage caused by external forces or any other external
factors.
Î Refer to the technical data and nameplate for limits and fields of application as well as
possible uses.
Reasonably foreseeable misuse
The regulators are not suitable for the following applications:
− Use outside the limits defined during sizing and by the technical data
− Use outside the limits defined by the accessories mounted on the regulator
Furthermore, the following activities do not comply with the intended use:
− Use of non-original spare parts
− Performing service and repair work not described in these instructions
− Changing parts, service or repair work on TÜV-tested Type 44-4 and Type 44-8
Qualifications of operating personnel
The regulator must be mounted, started up, serviced and repaired by fully trained and
qualified personnel only; the accepted industry codes and practices are to be observed.
According to these mounting and operating instructions, trained personnel refers to
individuals who are able to judge the work they are assigned to and recognize possible
hazards due to their specialized training, their knowledge and experience as well as their
knowledge of the applicable standards.
EB 2723 EN 5