Table of Contents
Advertisement
PREPARING THE SEWING MACHINE FOR USE
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagrams on pages 23 through 38 of this manual.
To Thread The Sewing Machine:
1.
CAUTION! Prior to performing this procedure, make sure the Power Switch
(18F) of the Sewing Machine is in its "OFF" position and the Power Wire
(29F) is unplugged from its electrical receptacle.
(See Figure D, page 8, and Figure I, page 12.)
2.
Remove the Moveable Sewing Table (13A) from the Needle Approacher (30A) by
pulling the Table to the left. Then lift the Table upward and off the Sewing
Machine. (See Figure E.)
FIGURE E
3.
Turn the Hand Wheel (9F) toward you until the Needle Holder (21B) is at its high-
est position. Loosen the two Setting Screws (23B) with the Hex Driver (7G).
Insert two new Needles (26B) into the Needle Holder as far as they will go
with their flat surfaces to the BACK. Then, re-tighten the two Setting Screws to
secure the Needles in place. (See Figures D and F.)
NEEDLE HOLDER
FIGURE F
SKU 91500
MOVEABLE SEWING TABLE (13A)
(21B)
NEEDLE
(26B)
NEEDLE APPROACHER
SETTING SCREW
PAGE 9
(30A)
(23B)
REV 12/04
Advertisement
Table of Contents
