Table of Contents
Advertisement
9.
Install a Hem Needle Plate Assembly (2E - not included), and replace the two
Needle Plate Screws (5E, 6E). (See Figure D and Figure P.)
10.
Replace the Moveable Sewing Table (13A). (See Figure D.)
11.
For rolled hemming, adjust the seam width to the position of "M" on the Hem
Needle Plate (3E). Then align the left edge of the Lower Knife Bracket (27D)
with the "M" mark on the Hem Needle Plate. (See Figure M.)
12.
NOTE: Make sure the Lower Knife (28D) is not in contact with the edge of the
Hem Needle Plate (3E). When performing rolled-hem stitching, make sure to
adjust the thread tension correctly. At the start of sewing, slightly pull the end of
the chain off so it will not be entangled in the stitch.
(See Figure M and Figure P.)
NEEDLE PLATE
SCREW
(5E)
NEEDLE PLATE
SCREW
(6E)
To Perform Free Arm Sewing (Tubular Work):
1.
This Sewing Machine can achieve tubular work by removing the Moveable Sew
ing Table (13A). This is especially convenient for finishing hard-to-reach areas
such as arm holes, overcasting trouser cuffs, etc. (See Figure D.)
To Perform Gathering:
1.
A single layer of light weight fabric can be gathered to achieve sleeve heads,
lower edges, yokes, leca edging, or frills. To do so, set the Feed Adjusting Knob
(21E) at its maximum "5". Set the Differential Feed Adjusting Stud (93E) from
"1.5" to "2". (See Figure D.)
SKU 91500
HEM NEEDLE PLATE
PAGE 18
(3E)
FIGURE P
Advertisement
Table of Contents
