Table of Contents
Advertisement
FIGURE O
NO. OF THREAD
OVERLOCK WIDTH
NEEDLE USED
STITCH TYPE
To Perform Roll Hemming:
1.
This Sewing Machine can do right looper thread/wrapped rolled hem stitching
with a seam width of approximately 1/16". When doing so, always remove the
left Needle.
2.
Rolled hemming is done by rolling the fabric and overedging, and is not suited for
heavy or stiff fabrics.
3.
CAUTION! Make sure the Power Switch (18F) is in its "OFF" position and the
Power Wire (29F) is unplugged from its electrical outlet before performing
this procedure. (See Figure D and Figure I.)
4.
To perform roll hemming, set the Feed Adjusting Knob (21E) to "2" or "F".
(See Figure D.)
5.
Turn the Hand Wheel (9F) toward you until the Needle (26B) is at its highest
point. (See Figure D and Figure F.)
6.
Lift the Presser Foot Assembly (1B). (See Figure J.)
7.
Remove the Moveable Sewing Table (13A). (See Figure D.)
8.
Unscrew the two Needle Plate Screws (5E, 6E) and remove the Needle Plate
(1E). (See Figure D and Figure P.)
SKU 91500
3 THREAD
3 THREAD
1/4" (5MM)
1/8" (3.5MM)
LEFT NEEDLE
RIGHT NEEDLE
PAGE 17
4 THREAD
1/4" (5.7MM)
LEFT & RIGHT NEEDLE
Advertisement
Table of Contents
