Before You Begin; Tools And Parts Needed; Parts Included; Appliance Dimensions - Bosch HCP50652UC Installation Manual

Before you begin

Tools and Parts Needed

• Measuring tape
• Pencil
• Phillips screwdriver (Posidrive) #2
• Drill with the following bits:
(9.5 mm)
• Spirit-level
• Aluminum tape (DO NOT use insulating tape)
• Exhaust channel (configuration depends on the
installation situation)
• Additional sheet metal screws (if necessary for
installation of the exhaust air duct)
• Saw
• Home power supply cable
• 1/2" (13 mm) UL listed or CSA approved strain relief
• Three UL Listed wire connectors

Parts Included

• Extractor hood with fan, back-pressure flap
• Lamps, already installed
• Metal grease filter
• Flue duct
• Drill template
• 1x angle bracket for the flue duct
• Installation manual and instructions for use
• 6x screws, 5x45 mm
• 12x screws, 4.2x8 mm
• 2x washers, 6.4x18 mm
• 2x hollow wall plugs, 8x40 mm
• 4x hollow wall plugs, 10x50 mm
• Torx adapter, 10 & 20
Page 6
⁄ " (7.9 mm) and ⁄ "
5 3
16 8
NOTE: Carefully remove the protective film from the duct
cover and hood assembly prior to the start of the installation.
Use one hand to maintain the assembly/duct cover steady
while the other hand removes the protective film.
Use gloves at all time.

Appliance Dimensions

10 / "
3
4
(273 mm)
13 / "
3
16
(335 mm)
30" (762 mm)
36" (914 mm)
A Only for circulating-air mode:
*Max. 43 ⁄ " (1106 mm)
1
2
*Min. 29" (734 mm)
Only for ducted operation:
*Max. 39 ⁄ " (1006 mm)
1
2
*Min. 25" (633 mm)
7 / "
7
8
(200 mm)
A
5¾"
(146 mm)
19 / "
11
16
(500 mm)