Table of Contents
Advertisement
3. Assembling and Installing
Draw the media holder (right) through the shaft on the front side.
Pass it through from the right edge (as seen from the back of the machine).
Hook the media holder (right) to the shaft on the back side.
Attach the retaining screw.
Only light tightening is necessary for the retaining screw. The retaining screw may get damaged if tight-
ened excessively.
Attach the shaft clamps.
The shaft is retained. Do not place the media holders too close to the edge so that they will not get
caught in the shaft clamps.
Hexagonal
wrench
Bolt
Shaft clamp
26
Tighten loosely.
Advertisement
Table of Contents
