Martec ASPIRE Installation Instructions

20cm
Aspire 3-in-1 Heater, Light and Exhaust
• The heater must be installed at least 1.8 m above the floor.
• The heater must not be located immediately below a socket outlet. The heater must not be located in front of a socket outlet. They should be
located outside the physical footprint of the units to minimize heat build up behind the heater.
• The standard power point must be installed by a licensed electrician.
• If the heater is to be mounted on an incline (eg. Sloping or angled ceiling), ensure the electrical connection is located at that lowest point of the
heater.
• Do not connect the appliance to the mains source until it has been installed in its final location and adjusted to the position it will be used in.
• Do not operate with the cord coiled up as this could cause a buildup of heat, which could pose a hazard.
• The use of an extension cord with this appliance is not recommended.
• Do not allow cord to come in contact with heated surfaces during operation.
• Do not run cord under carpeting, throw rugs or runners etc. Arrange cord away from areas where it is likely to be tripped over.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance
• The appliance is only intended for the purpose described in user manual.
• Do not use appliance or any part of the appliance out of the intended use to avoid risk.
• The use of attachments which are not recommended or sold by the appliance manufacturer may cause a risk of injury to persons
• CAUTION — some parts of this product can become very hot and cause burns. Particular attention has to be given where children and
vulnerable people are present.
• Install and operate the heater in strictly horizontal position on the ceiling or ceiling structural surface. The thermal resistance of the ceiling
coating and ceiling material should be at least 80 °C.
• WARNING: This heater is not equipped with a device to control the room temperature. The heater must not be within reach from the floor, as
severe burns may occur due to high surface temperatures. Do not use this heater in small rooms or where the room or area is occupied by
persons not capable of leaving the room on their own, persons who are unable to operate the heater safely and with the guidelines of the use
manual, unless constant supervision is provided.
• When the appliance is not in use and before cleaning, unplug the appliance from the outlet.
• To protect against the risk of electrical shock, do not immerse the unit, cord or plug in water or other liquid.
• Household indoor/covered outdoor use only.
ASPIRE
www.martecaustralia.com.au | 02 8778 7500 | sales@martecltd.com.au
28cm
Please read these instructions carefully before installing and using the product. Keep the instructions handy for future reference. Electrical
wiring must only be done by a licensed electrician and a "Certificate of Compliance" must be issued on completion of the installation.
WHAT'S IN THE BOX
• Bathroom unit
• Operating and Installation Instructions.
• Wall plate and switch.
• 1 x LED Light Panel
• Cutout Template

SAFETY INSTRUCTIONS

During use of the product, it is necessary to observe some precautions. Improper operation with disregard of precautions may result in
infliction of harm to health of the user and other people, as well as in infliction of damage to their property.
• Use only the voltage specified on the rating plate of the heater.
• This item should only be installed by a licensed tradesperson.
• The heater should be connected to the electric mains equipped with an automatic circuit breaker.
• The unit must be handled with care avoiding any sudden impacts or vibrations.
• Do not use the appliance areas where gasoline, paint or other flammable liquids are used or stored.
• Do not use the appliance in particularly in dusty or where explosives are stored.
• Do not use the appliance in a building site, green house, barn or in animal stables.
• Do not use the appliance as a sauna heater.
• Do not use this unit in the place of animal propagating and rising.
• Warming: To avoid burns, do not touch the appliance surface by hand and other body parts. It is also necessary to avoid touching the heater
whilst the appliance is switched on, as severe burns may result. The appliance can take up to 1 hour to cool down after switching it off.
• Do not place any items of clothing, hand towels or similar over the heater to dry. Risk of overheating and fire hazard.
• Do not leave the heater unattended whilst in use.
• Do not use this heater on a wet surface, or where it can fall or be pushed into water.
• Do not reach for an appliance that has fallen into water. Switch off at supply and unplug immediately.
• If the heater is defective, it must be checked and repaired by the manufacturer, its service agent or similarly qualified persons for repair.
• Do not operate appliance with wet hands.
• Use this appliance only as described in this manual. Any other use is not recommended by the manufacturer and may cause fire, electric shock
or injury.
• Do not use abrasive cleaning products on this appliance. If the body becomes dirty, wipe off dust with a cloth. Always remove plug from the
mains supply before cleaning.
Installation Instructions
Page 2 of 5
ASPIRE
Aspire Lux 3-in-1 Heater, Light and Exhaust
WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR POSITIONED CLOSE TO CURTAINS OR
OTHER COMBUSTIBLE MATERIALS.
www.martecaustralia.com.au | 02 8778 7500 | sales@martecltd.com.au
Installation Instructions
Page 1 of 5