Hyundai Elantra Manual page 31

Erasing HomeLink ® buttons
1. Press and hold the button (1) and
(3) simultaneously.
2. The indicator (4) is turned contin-
uously ON in orange for about 10
seconds.
3. Then the indicator (4) color
changes to Green and flashes
rapidly.
Release the buttons once the
green indicator flashes.
4. Now HomeLink button (1), (2) and
(4) memories are all cleared.
NVS ® is a registered trademark and
Z-Nav™ is a trademark of the Gentex
Corporation,
HomeLink ® is a registered trademark
owned by
Incorporated, Milwaukee, Wisconsin.
FCC ID: NZLUAHL5A
IC: 4112A-UAHL5A
i
Information
This device complies with Industry
Canada RSS-210 standard.
OOS047098C
Operation is subject to the following
three conditions:
1. This device may not cause harmful
interference.
2. This device must accept any inter-
ference received, including interfer-
ence that may cause undesired
operation.
3. The transceiver has been tested and
complies with RSS and Industry
Canada rules. Changes or modifi-
cations not expressly approved by
the party responsible for compli-
ance could void the user's authority
to operate the device.
Two Way Communication Programing
1. Complete
Zeeland, Michigan.
2. Before the first 10 times HomeLink
Johnson Controls,
3. Press and release the programed
the HomeLink
"Programming" first.
button is pressed after the pro-
gramming, the following steps
MUST occur to program two way
communication. (only for some
older garage doors)
OOS047099C
HomeLink button to activate the
garage door.
3
3-31