Wap Operator Technical Data - Sony Ericsson T628 White Paper

WAP Operator technical data

Feature
WAP Browser
Version
HTML
WAP Provisioning
Total Parameter sets
Parameter set list
Manual selection
Parameter sets include
Factory pre-configuration
OTA
Simultaneous OTA
Single OTA
Bookmarks
URL format
Security mechanism
OTA provisioning (if empty)
Interface (if empty)
Re-provisioning (Set 1 filled)
Interface (Set 1 filled)
Carrier reset/provisioning
Support in the T630/T628 for WAP
2.0 baseline
XHTML, mobile profile
5
Name
Startpage
IP settings:
CSD phone no., CSD Data rate, CSD dial type
GPRS APN, password request, allow calls, authentication,
data compression, header compression, quality of services
IP address, datamode
UserId and password
Security on/off
Show images on/off
Response timer
Yes, between Analog (V32) and Digital (V110)
WAP/CSD, WAP/GPRS (different sets)
WAP/CSD (possibility to lock a setting), WAP/GPRS
WAP/CSD, WAP/GPRS configuration possible
WAP/CSD, WAP/GPRS configuration possible
WAP/CSD, WAP/GPRS is not possible
Not empty by default
Underlined
Operator verification through a code, included in the OTA data.
This code is shown to the user who can choose installation or
not.
An Install question is asked with the code, if available.
The user has to choose if a new WAP profile shall be created or
an existing profile shall be replaced.
As above
As above
Yes, but not if the set is pre-configured in the factory and locked.
72
T630/T628
White Paper
October 2003