Table of Contents
Advertisement
Congratulations for purchasing an environmentally friendly electronic water
TM
conditioner, and thank you for choosing the Scalewatcher
system to treat your home
or swimming pool. Please read this short manual in its entirety for a quick and
successful installation.
YOUR BOX CONTAINS:
SCALEWATCHER™ energizing unit
UL approved AC/DC switching power supply
One core signal cable of sufficient length
Six cable ties
Four screws with wall anchors.
Instruction manual
INSTRUCTION MANUAL
INSTALLATION SITE
Locate the incoming water supply and if possible find a straight length of pipe after the
water meter (if any) of at least four inches. The pipe can be horizontal, vertical or
diagonal. The unit has to be installed indoors. However if there is not enough space in
the house for the coil, the coil can be wrapped around the pipe in the open. In that
case cover the coil with duct tape to protect it from moisture and rain.
If no electrical outlet is present near the installation site, consult a qualified electrician.
In case the water supply is from a roof tank, install the coil after the tank. The signal
coil should not be closer than six inches from any major steel/iron objects, motors and
appliances for best performance.
Install the SCALEWATCHER™ System unit upstream of the water softener if you plan
to run them together. If you have a whole house water treatment system, install the
SCALEWATCHER™ upstream for best results. See also page 6.
3
Hide quick links:
Advertisement
Table of Contents
