Maintenance - Harbor Freight Tools Chicago Electric Power Tools 40124 Assembly And Operating Instructions Manual

6. When the towing is complete, secure the load so it cannot move in either direction,
then remove the Switch Assembly from the Solenoid Cover.
Caution: The Electric Winch is designed for intermittent use only, and should not be
used in a constant duty application. The duration of the pulling job should be kept as
short as possible. If the Winch motor becomes very hot to the touch, stop the Winch and
let it cool down for several minutes. Never pull for more than one minute at or near the
rated load. Do not maintain power to the Winch if the motor stalls as it can damage the
motor or gears.
Lubrication
1. All moving parts within the Electric Winch have been lubricated using high temperature
lithium grease at the factory. No internal lubrication is required.
2. Lubricate Aircraft Wire Rope (38) periodically using a light penetrating oil.
Cable Assembly Replacement
1. Move Clutch Handle Assy (4) to the Out position.
2. Extend Aircraft Wire Rope to its full length.
Note how the existing cable is connected to the inside of the drum.
3. Remove old Cable Assembly and attach new one.
Caution: Do not replace with inferior cable. Always use the approved replacement part
from Harbor Freight Tools.
4. Retract Cable Assembly onto cable drum being careful not to allow kinking.
General
1. Keep battery in good condition.
2. Be sure that the Electric Winch battery cables are not drawn tight against any
surfaces which could possibly damage them.
3. Periodically remove and clean cable connections to the battery. Corrosion will reduce
performance or may cause a short.
4. Cover the Cable Assembly and Electric Winch when not in use.
SKU 40124

Maintenance

Page 8