Use Of The Mist Blower; Roadworthiness; Identification Plate; Chassis - Hardi Mercury Series Instruction Book

Use of the mist blower

The HARDI mist blower is designed for applying chemical products used for crop protection. This equipment may only be
used for this purpose. The use of this equipment for other purposes is not allowed. If there is no special law in your region
which obliges the user to have a permit, it is recommended to be well-prepared for protecting crops in a correct way and
for handling chemical products safely so as to avoid unnecessary risks to people and the environment while spraying takes
place.
For environmental issues the air kit is offered with option to close either left or right side of the air stream from the blower.
These blinds, are mandatory in some sensitive areas, to avoid chemical contaminated air, blowing towards river sides and
water channels

Roadworthiness

When driving on public roads and other places where the road safety code or where there are other special rules and
regulations for marking and lights on machinery, the machine must be equipped to comply with these regulations.
μ
ATTENTION! For models not fitted with brakes the maximum speed is 25 km/h and 40 km/h for those with. This could
vary according to local legislation. Contact your local authorities to find out the current maximum speed limits.

Identification plate

The identification plate is located on the front right-hand side of the
machine and is riveted to the chassis. It indicates the make, model, serial
number, and date of manufacture.
The serial number is also engraved onto the chassis. The number is
found above the identification plate, as indicated in the picture. The
serial number consist of five digits.
The serial number is also engraved onto the chassis. The number is
found above the identification plate, as indicated in the picture. The
serial number consist of five digits.

Chassis

The monoblock cold-pressed metal chassis is highly durable and built to last under everyday use under extreme conditions.
It is manufactured using only the most advanced laser cutting and automated soldering processes. To protect against
corrosion it is coated with a polyurethane bi-component paint on top of a highly adherent, steel blasted base.
3 - Description
HARDI AUSTRALIA PTY. LTD.
SERIAL NUMBER
33