Package Contents; General Speaker Placement - ONSIA Sound Art Series Installation Manual & Operating Instructions

INSTALLATION GUIDE
Recommended Tool List (Wall Mount Units)
Phillips screw driver, Hammer, Pencil, Measuring tape, Level, Drill

Package Contents

1 Bluetooth® Sound Art speaker.
1 Wall Charger.
1 Wall Mount Kit: Z bar (2 pieces) and Wall screws.
1 Installation guide & operating instructions document.

General Speaker Placement

Because of the unique technology used in the design of your Bluetooth® Sound Art™
speaker, there is more flexibility
other words, the location of the speaker can be based on interior design requirements as well as
acoustical considerations. However, do not place your Sound Art™ in corners, as this tends to create
reverberation and sonic reflections.
Mounting Height (Wall Mount Models)
When determining the mounting height, simply follow the same principles that you normally do when
hanging traditional artwork. The height of the speaker is conditional to the area. If it is to be located
in a living room, dining room, or bedroom, where people are seated, then it should be hung at eye
level. The eye will be drawn to the focus of interest in the art or picture, and sound will be at ear level.
In hallways and entrance ways, consider the fact that people will be standing, and eye level (and
ear level) will change accordingly.
Installation on Wall
•
Determine the position on the wall where you would like the top of the speaker to be positioned
and lightly mark the wall with a pencil at the center point of the top edge of the frame.
•
Measure 1 1/8" below your pencil mark and draw a horizontal line using a level.
•
Centrally and along this line mark the hole placements 2" apart.
•
Attach the Z bar pieces to the wall and your speaker using the hardware provided as shown
in the diagram below. Attach one piece of Z bar to the wall with the wall anchors and wall
anchor screws provided. Attach the remaining Z bar piece to your speaker with the machine
screws provided. Your speaker has metal screw inserts that allow you to hang it in a horizontal or
vertical configuration. Choose the appropriate configuration according to the art on your speaker.
•
Install the right-angle DC jack extender by inserting it into the DC jack located in the back of the
speaker.
•
To hang the speaker, gently slide the unit down the wall until the two sections of Z bar interlock.
It is important to ensure that the top piece is fully seated with the bottom piece (you should feel
the pieces sliding together).
•
Gently pull down on the speaker to make sure that it is secure.
in placing it relative to the primary listening area.
3
and Ladder.
In