Advertisement
<<< Jacks & Signal Path >>>
The audio jacks are located on the north side of the pedal, along with the 9v 410mA power jack.
The Avalanche Run has a stereo analog dry path, a dual mono delay path and a stereo reverb.
To Run Mono
Use the left input and output only.
To Run Stereo
Use both left and right inputs and outputs
To Run Mono In and Stereo Out
Use the left input and both left and right outputs
6
<<< Cool Trick >>>
Plugging into the right input and using the left and right outputs will give you an all-wet left
channel and a standard mixed right channel while the effect is engaged. You can create dramatic
stereo effects by keeping the Mix set low and turning up the amplifier source connected to the
left output. The left output will not pass dry signal when the effect is turned off in true bypass
mode but trails mode it will still produce the effected signal as long as it is set to decay.
<<< Expression Jack >>>
The expression jack is located on the west side of the pedal. It is a TRS jack with the tip acting
as the wiper.
• We recommend using a Moog expression pedal with the output adjustment knob all the
way up.
• We cannot guarantee any other expression pedal to work with the Avalanche Run.
<<< Flexi-Switching >>>
This device features Flexi-Switch
Technology! This relay-based, true bypass switching style
™
allows you to simultaneously use momentary and latching style switching.
• For standard latching operation, tap the footswitch once to activate the effect and then tap
again to bypass.
• For momentary operation, hold the footswitch down for as long as you'd like to use the effect.
Once you release the switch the effect will be bypassed.
Since the switching is relay based, it requires power to pass signal.
7
Advertisement
