Summary of Contents for Wall Bed Factory Mission
- Page 1 Wall Bed Factory Assembly Instructions Mission Mission Horizontal Murphy Bed Murphy Bed Camden Farmhouse Hudson Murphy Bed Murphy Bed Murphy Bed...
-
Page 2: Tools Needed
TOOLS NEEDED: A. Stud Finder B. Flathead Screwdriver C. Power Drill w/ Phillips Head Screwdriver Bit & Drill Bits Phillips Head Screwdriver Bit INCLUDED HARDWARE: Bed Installation Parts A. Air Pistons (2) B. 3” Sheet Rock Screws (4) C. 1 5/8” Hexagonal Screws (4) D. - Page 3 PART A: Assembling Wall Bed Step 1: Remove Wall Bed from packaging (package includes 5 bed pieces). Retrieve 2 blue-green Foam Pieces from Side Panel packaging to use in a later step. Determine where you want to position Wall Bed. Place Head of Bed 18” from wall. Lay out other pieces as shown below.
- Page 4 Step 2: PARTS NEEDED: STUD FINDER, PENCIL, MEASURING TAPE Use Stud Finder to find and mark location of 2-4* studs along wall across width of Wall Bed. Placement of marks will depend on bed size/type. Mark studs on wall at the following heights: Vertical Beds Horizontal Beds Twin...
- Page 5 Step 3: PARTS NEEDED: FLATHEAD SCREWDRIVER Remove E-clip from Right Side Panel (see A) by inserting Flathead Screwdriver between E- clip and Pivot Bar and rotating screwdriver 90° (see B). E-clip WallbedFactory.com Assembly Instructions Page 5 of 19 1.800.975.8451 Tube Leg Murphy Beds...
- Page 6 Step 4: Lift Right Side Panel onto its long edge (see A) and slide toward Bed Frame, inserting Pivot Bar through metal plate on Bed Frame (see B). WallbedFactory.com Assembly Instructions Page 6 of 19 1.800.975.8451 Tube Leg Murphy Beds...
- Page 7 Step 5: Put E-clip back on Pivot Bar by sliding E-clip into grooves on Pivot Bar until it snaps into place. E-clip Step 6: Repeat steps 3-5 on left side of bed for Left Side Panel installation. Both Side Panels are now attached to Bed Frame.
- Page 8 Step 7: PARTS NEEDED: FOAM BLOCKS At Foot of Bed, pivot both Side Panels slightly out and away from Bed Frame so bumpers on Side Panels are out of way. Lift Foot of Bed 6” to 8” and slide Foam Blocks underneath to keep Bed Frame elevated for the following steps.
- Page 9 Step 9: Have your helper stand at Foot of Bed and raise/lower Bed Frame (see A) to align Piston Head at wide end of Air Piston with Pivot Ball on Side Panel Plate, while you Pop Piston Head onto Pivot Ball (see B).