Page 3
Read this manual in its entirety before attempting to use this product. Damage resulting from misuse or modification will void your warranty. Venom will not be held responsible for any incidental damages or injury to persons that may result from improper use of this product.
venompower.com CHARGING BATTERIES CAN BE HAZARDOUS Before attempting to charge or discharge a battery, first read the safety warnings and instructions provided with your battery. Contact the battery manufacturer if these instructions were not provided or are unclear. Before charging or discharging any battery, carefully inspect the pack to ensure no physical damage, swelling or “ballooning”...
PROPOWERHD FEATURES Simple user interface with balance charge and storage modes Supports 2S-6S LiPo (4.2V/cell) and LiHV (4.35V/cell) batteries Independent charge ports for 2S and 3S radio batteries Auto recall of last charge settings Over-voltage, over-current, over-temperature and reverse polarity protection SPECIFICATIONS Input Voltage: 110-220VAC...
venompower.com EXTERIOR OF UNIT FRONT LCD Display Charge Current LED Status Buttons Indicators Charge/Storage Mode Buttons Start/Stop Buttons LEFT RIGHT JST-XH Balance ON/OFF Sockets Switch Indicator AC Power 2S/3S Radio Battery XT90 Charge Input Charge Ports Ports 0609 venompower.com...
PROPOWERHD USING YOUR CHARGER For the charger to operate it must be plugged into an AC power source and the ON/OFF switch located on the left side of the unit must be in the ON position. BALANCE CHARGE OPERATION 1. Connect the battery main lead output to one of the two XT90 charge ports using a plug converter as necessary.
3. The charge process is complete when the LED indicator glows GREEN. LiPo AND LiHV MODE SELECTION The Venom Pro Power HD is configurable to balance charge standard Lithium Polymer (LiPo) batteries as well as High Voltage Lithium Polymer (LiHV) batteries.
Display 2 LCD DISPLAY & LED STATUS INDICATOR The Venom Pro Power HD LCD display provides valuable at a glance status information across two channel display screens which cycle every few seconds during active operations. 1. Current Battery Voltage: The measured voltage from the battery main leads.
Temperature protection active – Check to verify that the cooling fan is INT. TEMP High operating and move the charger to a cooler location as necessary. Over-Current protection active – Over Load Current has exceeded 30A, please contact Venom Customer Success. 0609 venompower.com...
® for the purchase price of such products. The above warranty does not cover software, which is provided as part of Venom® products on an AS IS basis, with no warranties. Other Warranties...
Page 13
Venom , It’s affiliates, manufacturers, distributors, or retail partners shall not be held liable for any ® accident, injury to persons, or damage to property resulting from use, misuse, or abuse of any Venom ® product. In purchasing a Venom product the user agrees to accept responsibility for all such risks.
Page 16
VENOM GROUP INTERNATIONAL 14028 N. Ohio Street Rathdrum, Idaho 83858 USA CUSTOMER SERVICE For quick customer support please visit www.venompower.com and click the support tab. /venomgroupintl /venomgroup /Venom_RC /venomgroup 0609 CAN ICES-3(B) / NMB-3(B)