Troubleshooting - JVC KD-T409 Instruction Manual

TROUBLESHOOTING

Symptom
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
The unit does not work at all.
Correct characters are not • This unit can only display uppercase letters, numbers,
displayed.
• Depending on the display language you have selected
• Radio reception is poor.
• Static noise while listening
to the radio.
Disc cannot be ejected.
Noise is generated.
"IN DISC" appears and disc
cannot be ejected.
"PLEASE EJECT" appears.
Playback order is not as
intended.
Elapsed playing time is not
correct.
16
ENGLISH
Remedy
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 5)
Reset the unit. (Page 3 or 4)
and a limited number of symbols.
(page 6), some characters may not be displayed
correctly.
Connect the antenna firmly.
Press and hold to forcibly eject the disc. Be careful not
to drop the disc when it is ejected.
Skip to another track or change the disc.
Make sure nothing is blocking the loading slot when you
eject the disc.
Press , then insert the disc correctly.
The playback order is determined by the order in which
files were recorded (disc) or the file name (USB).
This depends on the recording process earlier (disc/USB).
Symptom Remedy
"NOT SUPPORT" appears and Check whether the track is a playable format.
track skips. (Page 14)
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reload the disc or reattach the device (USB).
"CANNOT PLAY" flashes and/ • Check whether the connected device is compatible with
or connected device cannot this unit and ensure the files are in supported formats.
be detected. (Page 14)
• Reattach the device (USB).
"NO DISC" Insert a playable disc into the loading slot.
"NO DEVICE" Connect a device (USB), and change the source to USB
again.
• Sound cannot be heard • Reconnect the Android device.
during playback. • Launch any media player application on the Android
• Sound output only from device and start playback.
the Android device. • Relaunch the current media player application or use
another media player application.
• Restart the Android device.
• If this does not solve the problem, the connected Android
device is unable to route the audio signal to unit.
(Page 14)
• If USB connection does not work, connect the Android
device through auxiliary input jack.
"NO DEVICE" or "READING" • Reconnect the Android device.
keeps flashing. • If USB connection does not work, connect the Android
device through auxiliary input jack.