Moisture Condensation - Sony Playstation 2 SCPH-35001 GT/97010 Instruction Manual

2
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not disassemble.
Refer servicing to qualified personnel only.
Caution
The use of optical instruments with this
product will increase eye hazard. As the
laser beam used in this unit is harmful to
eyes, do not attempt to disassemble the
cabinet.
Refer servicing to qualified personnel only.
This label is located on the Laser protective housing inside
the enclosure.
This graphical symbol with supplemental marking is
located on the right surface of the unit (when it is in a
vertical position).
This symbol is intended to alert the user to the
presence of uninsulated "dangerous voltage"
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
This symbol is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the console.
Caution
TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT.
Information
For Customers in the USA
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
If you have any questions about this product, you
may call:
Sony Computer Entertainment America PlayStation
Consumer/Technical Support 1-800-345-SONY or
write to : PO Box 5888 San Mateo, CA 94402-0888
Declaration of Conformity
Trade Name : SONY
Model No. : SCPH-35001
Responsible Party : Sony Electronics Inc.
Address : 680 Kinderkamack Road,
Oradell, NJ 07649 U.S.A.
Telephone No. : 201-930-6972
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
Before operating your PlayStation 2 console
®
A few people may experience epileptic seizures when
viewing flashing lights or patterns in our daily environ-
ment. These persons may experience seizures while
watching TV or playing video games, including DVD
videos or games played on the PlayStation 2 console.
®
Players who have not had any seizures may nonetheless
have an undetected epileptic condition.
Consult your physician before operating the PlayStation
console if you have an epileptic condition or experience
any of the following symptoms while watching TV
programs or playing video games: altered vision, muscle
twitching, other involuntary movements, loss of
awareness of your surroundings, mental confusion, and/
or convulsions.
Owner's Record
The model and serial numbers are located on the rear of
the PlayStation 2 console. Record the appropriate
®
number in the space provided below. Refer to these
numbers whenever you call for technical assistance at
1-800-345-SONY.
Model No. SCPH-35001
Serial No. _______________________________
Precautions
Disc handling
• Do not leave discs near a heat source, in direct sunlight,
or in high humidity.
• Store discs in their cases when they are not being used.
Stacking discs or standing them at an angle without
putting them in their cases can cause the discs to warp.
• Do not touch the disc surface when handling a disc;
hold it by the edges.
• Do not stick paper or tape onto the disc.
• Do not write on the disc with a marker, etc.
• Fingerprints or dust on the disc can distort the picture
or reduce sound quality. Make sure discs are always
clean before use.
• Clean discs using a soft cloth, lightly wiping from the
center outwards.
• Do not use solvents such as benzine, commercially
available cleaners not intended for CDs or anti-static
spray intended for vinyl LPs as these may damage your
disc.
Do not place the console in an unusually hot
location
Do not leave the console in a car with its windows closed
(particularly in summer) as this may warp the exterior of
the console or cause the console to malfunction.

Moisture condensation

If the console or the disc is brought directly from a cold
location to a warm one, moisture may condense on the
lens inside the console or on the disc. Should this occur,
the console may not operate properly. In this case, remove
the disc and do not put the disc back in until the moisture
evaporates. (This could take several hours.) If the console
still does not operate properly, call 1-800-345- SONY for
technical assistance.
Do not subject the console to violent
physical shock
Do not throw or drop the console or its accessories, and do
not knock the console or its accessories against other
objects. When carrying the console, do not subject it to any
type of violent physical shock. This may damage the disc
or cause the console to malfunction.
2
®
Avoid damaging the exterior of the console
Do not apply any solvents, and do not place any rubber or
vinyl materials on the surface of the console for an
extended period of time. Doing so may damage the plastic
surface or cause the paint to peel off.
Cleaning the exterior of the console
When cleaning the exterior of the console, be sure to turn
the power off with the MAIN POWER switch on the back
of the console and disconnect the AC power plug from the
electrical socket.
• If the exterior of the console becomes dirty, soak a soft
cloth in a mild detergent solution diluted with water,
tightly squeeze the cloth to remove the excess liquid,
wipe the affected area of the exterior and finish by
wiping with a dry cloth.
• Do not use benzine or paint thinner to clean the exterior
of the console since these may damage the surface or
cause the paint to peel off. When using a chemically-
treated dust cloth, follow the usage instructions
supplied with it.
Never disassemble the console
• Use your PlayStation 2 computer entertainment
®
system according to the instructions in this manual. No
authorization for the analysis or modification of the
PlayStation 2 console, nor the analysis and use of its
®
circuit configurations, is provided herein.
• There are no user-serviceable components inside the
PlayStation 2 console. Disassembling it will void the
®
warranty. Additionally, there is a risk of exposure to
(laser) radiation as well as to electrical shock hazards.
Notes on safety when using the analog
controller (DUALSHOCK ™ 2) and analog
controller (DUALSHOCK ™ )
• Stop using this console immediately if you begin to feel
tired or if you experience discomfort or pain in your
hands and/or arms while operating the controller. If
the condition persists, consult a doctor.
• Do not attempt to operate the controller in any way
except with your hands. Do not bring the controller
into close contact with your head, face or near the
bones of any other part of your body.
• The vibration function of the analog controller
(DUALSHOCK 2) or the analog controller
™
(DUALSHOCK ) can aggravate injuries.
™
Do not use the vibration function of the analog
controller (DUALSHOCK 2) and analog controller
™
(DUALSHOCK ) supported by software if you have
™
any ailment in the bones or joints of your hands or
arms.
• Do not use the analog controller (DUALSHOCK
™
the analog controller (DUALSHOCK ) with software
™
that supports the vibration function if you have injuries
or ailments to the bones or muscles of your fingers,
hands, wrists or arms. The vibration of the controller
may aggravate such conditions.
• Avoid prolonged use of the analog controller
(DUALSHOCK 2) and analog controller
™
(DUALSHOCK ). Take a break at about 30 minute
™
intervals.
2) or