Table of Contents
Advertisement
Unpack the system
1. In addition to the assembled unit, these components
are packed loosely or separately: hose set, gun,
instruction manuals. These are the manuals you
should receive:
308369
Pressure pot
308167
Air regulator
312414
HVLP spray gun (Model 237413)
312414
Air spray gun (Model 237409)
Connect the hose set and gun to
the system
See F
. 1 on page 6
IG
1. Connect the air hose (43) between the gun air shut-
off valve (17a) and the air inlet of the spray gun.
These are 1/4- 18 npsm swivel fittings.
2. Connect the fluid hose (40) between the fluid shutoff
valve (18) and the fluid inlet of the spray gun. These
are 3/8- 18 npsm swivel fittings.
3. Verify that all fittings throughout the system are
tightened securely.
Ground the system
The equipment must be grounded to reduce the risk
of static sparking. Static sparking can cause fumes to
ignite or explode. Grounding provides an escape wire
for the electric current. Check your local electrical
code for detailed grounding instructions for your area
and type of equipment.
Ground all of this equipment:
Pressure pot: One end of the ground wire (13) is
already connected to the pressure pot. Connect the
other end of the ground wire to a true earth ground.
Air compressor: Ground according to manufacturer's
recommendations.
Object being sprayed: Ground according to local code.
Fluid supply container: Ground according to local
code.
All solvent pails used when flushing: Ground accord-
ing to local code. Use only metal pails, which are con-
ductive. Do not place the pail on a non-conductive
surface, such as paper or cardboard, which interrupts
the grounding continuity.
Setup
7
Advertisement
Table of Contents
