Piper APACHE PA-23-235 Service Manual page 1337

NATURE OF INSPECTION
D. CABIN AND COCKPIT GROUP
1. Inspect cabin door, latches, and hinges, and windows, and
baggage compartment doors, latches, and hinges for damage, operation,
and security ............................................................................................................
2. Inspect windows for scratches, crazing, and condition..........................................
3. Check operation of emergency exit window..........................................................
4. Check window and door seals for deterioration, cracks, and voids .......................
5. Inspect upholstery for tears ....................................................................................
6. Inspect seats, seat belts, shoulder harnesses, security brackets, and bolts per
Restraint System Inspection in Special Inspections, Procedures...........................
7. Inspect trim operation ............................................................................................
8. Inspect condition and operation of rudder pedals and
rudder bar assembly ...............................................................................................
9. Inspect parking brake valve and brake handle for operation
and cylinder leaks...................................................................................................
10. Check operation of parking brake..........................................................................
11. Inspect condition and security of control wheels, column, pulleys,
cables, turnbuckles, guides, terminals, and fittings, and on
S/Nos. 27-8054001
12. Inspect flap lever to control cable attachment bolt for condition and security.
(See Notes 9 and 10.) .............................................................................................
13. Check operation of landing, navigation, strobe, cabin, and instrument lights .......
14. Inspect condition and security of instruments, avionics,
lines, and attachments ............................................................................................
15. Inspect instruments central air filter lines and replace filter ..................................
16. Inspect vacuum and gyro operated instruments and
electric turn and bank. (Overhaul or replace as required.).....................................
17. If installed, clean or replace vacuum regulator filter .............................................
18. Inspect static system, altimeter and transponder for installation/certification
per latest revision of AC43.13-1 and current test/inspection
per FAR's 91.411 and 91.413, respectively ...........................................................
19. Inspect and test ELT per FAR 91.207. (See Testing ELT, Paragraph 12-7.) ..........
20. Inspect operation of fuel selector valve .................................................................
21. Inspect fuel selector valve control cables for rigging and adjustment,
unrestricted motion of cables, cable ends, and valve actuator levers.
(See Note 20.) ........................................................................................................
22. Drain crossfeed line ...............................................................................................
23. Check operation of crossfeed valve .......................................................................
24. Check operation of heater fuel valve .....................................................................
07/15/06
PIPER AZTEC SERVICE MANUAL
TABLE III-I. INSPECTION REPORT
and up, bobweight installations. (See Notes 9 and 10.) .........
6C19
Inspection
Interval (Hrs)
50 100
O
O
O
O
O
O
O
O
O
O
O
O
O O
O
O
O
O
O
O
O
O
O O
O
O
III - Inspection