Table of Contents
Advertisement
5.1.15 Setting for perfect alignment when
the machine is turned round
Symmetry of cut is factory set using a calibrated
disc and without any paper shims.
Use of paper or cardboard shims by the customer
may lead to an offset cut when the machine is
turned round.
This fault can be corrected by adding or
removing set-rings Ref.① (depending on the
offset observed).
In the case shown in the figure below, set-rings
with a thickness equal to e/2 must be added. If
the situation is the reverse, then rings must be
removed.
To change the offset :
➊ Unscrew the two screws Ref.③ and remove
the turn-around sleeve Ref.② from the
machine.
➋ Add or remove set-rings.
➌ Put the turn-around sleeve back in place,
tapping it firmly into contact with the front
bearing Ref.④ with a few blows with a
wooden hammer (after slightly tightening the
two screws Ref.③).
➍ Firmly tighten the two screws Ref.③ at a
torque of 3 daN.m.
5.1
e
Gap =
1
2
MTZ_Gb_00310_070614.doc
st
1
cut feature
(before reversing)
3
4
5.1
Hide quick links:
Advertisement
Table of Contents
