Starting Up The Machine - GEISMAR STUMEC MTZ 350S Manual

4.3 Starting up the machine

Do not start up the engine until the machine has been fitted to its guiding vice, which must already have been fixed to the rail in the correct position
for the cut.
Starting :
➊ Press the accelerator trigger lock Ref.① and
the accelerator trigger Ref.② at the same
time. With these two units pushed in, push the
combined action lever Ref.③ to the START
position. Then successively release the
accelerator trigger, the combined action lever
and the accelerator trigger lock.
3
➋
Set the position of the choke Ref.④ to
ambient temperature
temperature:
- If the engine is cold, put the choke lever to
the position.
4.3
- If the engine is hot (also if the engine has
already been running, but is still cold or even
if a hot engine has been stopped for less than
five minutes), put the choke lever in the
position
- If the engine is very hot (if a very hot engine
has been stopped for over five minutes), put
the choke lever in the
1
4
➌ To
make
decompression valve button Ref.⑥ (This
button must be pressed every time you try to
start the machine).
2
➍ Push in the priming pump diaphragm Ref.⑤
7 to 10 times (even if it is full of fuel).
and to engine
5
position.
starting easier, press the
6
MTZ_Gb_00298_070525.doc
➎ To make starting easier and avoid any risks of
accident, the lower part of the disc guard
Ref.⑧ must be laid on the railhead as shown
in the photograph below.
Grip the rear handle Ref.⑨ of the rail-cutting
machine firmly in one hand. With the other,
pull the starting cord handle Ref.⑦ gently
upwards until you feel the compression. Then
pull sharply.
Do not pull the cord out completely. Do not
release the handle to let the cord wind itself
up without any control, but accompany the
return movement gently by hand to let the
cord re-wind itself in position correctly. Never
wind the starting cord around your hand.
7
9
8
4.3