Replacing The Starter Cord - GEISMAR STUMEC MTZ 350S Manual

Re-fit the support plate Ref.⑦ after
11
inserting the two screws Ref.⑪ in the
corresponding holes in the engine chassis
Ref.⑧, insert the flat of special bolt Ref.⑨
in the groove in the engine chassis and
tighten screw Ref.⑫. Screw in the three
screws by hand without tightening them
12 Re-fit the "front-plate, disk housing and
driven pulley" sub-assembly on the main
support plate, and firmly tighten the 3
screws Ref.⑥. When re-assembling, check
that the flutes on the belt are in line with
the grooves in the driven pulley.
Tighten the belt by turning the tension
screw about 1/8 of a turn clockwise. The
spring will then act on the tension screw
and hold it against its stop.
Hold the multi-purpose
firmly.
Do not turn the multi-purpose spanner
by forcing it.
In this position, the belt is tensioned
automatically by the strength of the spring.
13 Firmly tighten the 2 screws Ref.⑪ and
screw Ref.⑫ (multi-purpose spanner).
IMPORTANT: The tension must be adjusted
on a new belt after two fuel fill-ups, by
proceeding as follows.
5.1
Adjusting belt tension
The tension screw does not require to be
moved for adjusting belt tension.
➊ Unscrew the 2 screws Ref.⑪ and screw
Ref.⑫ (multi-purpose spanner)
➋ The belt is tensioned automatically by the
force of the spring.
➌ Retighten the 2 screws Ref.⑪ and screw
Ref.⑫.
spanner
MTZ_Gb_00306_070525.doc

5.1.8 Replacing the starter cord

➊ Turn tension screw Ref.① to position "0"
(multi-purpose spanner).
➋ Unscrew the 2 screws Ref.② and screw
Ref.③ by five turns (multi-purpose spanner).
➌ Remove the starter cover as per instructions 7)
and 8) described above.
➍ Remove
11 12
screwdriver or a suitable pair of pliers).
➎ Extract cable pulley Ref.⑥ with washer
Ref.④ and the two pawls Ref.⑦.
1 2 3
the snap-ring Ref.⑤ (use
4 5
6
7
a
5.1