Unpacking Unit; End Glass Removal - Duke FLM200 Installation And Operation Manual

UNPACKING UNIT

Inspect the shipping carton and/or container,
carefully noting any exterior damage on the delivery
receipt; also note any damage not evident on
the outside of the shipping container (concealed
damage). Contact the carrier immediately and file a
damage claim with them. Save all packing materials
when filing a claim. Freight damage claims are the
responsibility of the purchaser and are not covered
by the warranty.
• Inspect unit for damage.
• Report any dents or breakage to source of
purchase immediately.
• Do not attempt to use unit if damaged.
• Remove all materials from unit interior.
• If unit has been stored in extremely cold area,
wait a few hours before connecting power.
Unpack and inspect unit. Remove outer corrugated
box from skid and remove tie down angles from skid
and unit. Set unit on floor.
Note: Box with bread baskets and kick
plates are inside and under unit.
Step 1
If the unit next to the bread display has an existing
end glass, this will need removed before installing
the bread cabinet.
If not proceed to step 1 of installation.
Step 2
Using a 7/16 wrench and nut driver, remove the
two bolts and nuts holding the end glass in place.
Discard the bolts only. (Save nuts for future step.)
NOTE: be careful not to drop the glass.
UNPACKING UNIT

END GLASS REMOVAL

Installation and Operation of: Front Line Merchandiser
Baskets
Remove
Kickplates
5