Sleeve Replacement & Stowage Of Lid, Guidelines - Wallgate CWC-LOK-LID Product Manual

Product Manual CWC-LOK-LID
6.2.1 Sleeve replacement & Stowage of Lid, guidelines
WARNING! When handling the Lockable Lid assembly it is advisable to practice good
hygiene & infection control & suitable PPE should be used.
1 Prior to stowage of Lockable Lid assembly, with the Lid resting face down & 'J' bolt
protruding above the Lid in its fully extended out end stop position. Cut the Hygiene
Sleeve retaining band & dispose of, allowing nested portion of Sleeve to be free.
Remove the Sleeve from the 'J' bolt & dispose of. Fig. 7.
2. Whether stowing the Lid assembly with or without fitting a new Sleeve. It is
advisable to clean the complete unit with a proprietary disinfectant. To fit a new
Sleeve, squarely cut a 60cm length of Hygiene Sleeve, feed approx. 30cm of the
Sleeve over the 'J' bolt. The remainder of sleeve folded back & nested into hook of 'J'
bolt & secured with a new band, see Figs.1 & 2. To prevent edge of lid & 'J' bolt
damage, stow the clean Lid assembly face down onto a non abrasive surface with 'J'
bolt fully extended out & preferably installed with new Hygiene Sleeve ready for
next use.
Figure 7
Replacement of
Hygiene Sleeve &
stowage of unit:
12
Wallgate
2019
|Revision 5.0